The GrooveLight luminaires bring each tile to life with sparkling lighting effects in the joints. OIn the bathroom or the hallway, these LED luminaires set brilliant highlights and offer orientation in the dark. GrooveLight is robust enough to walk on, which means it can be used in wall and floor tiling. Its IP67 protection makes it safe to use in wet rooms, e.g. bathrooms.
Prepare all the materials you need. You can extend the GrooveLight basic set with four LED luminaires (product no. 93756) to 48 light points (product no. extension set 93757).
Insert the GrooveLight luminaire in the tile joint (at least 3 mm wide) and route the electric cable in the joint as well.
Connect the plug-in cables between the individual GrooveLight luminaires. The cables can also be routed diagonally. (Cable length from light point to light point: 105 cm.)
Use shrink tubing over the connections, once everything is plugged together.
Use a lighter or hot air pistol to shrink the tubing. It will contract around the contact points for protection.
Continue routing the cable in the joint.
Once you have placed all the luminaires, laid out all the cable, made all connections and tested everything for correct function, you can then close the joints with watertight joint filler.
Done!
A Note on Safety
Please be very careful when you connect the luminaires to the mains power supply to prevent electrocution. Turn off the electricity at the fuse box and then use a voltage tester to make absolutely sure that the connection is not live. You should also read the installation instructions carefully before you start with the installation. Please get a qualified electrician to assist you if you are not comfortable doing the installation yourself, or if a mains connection is not available at the installation location.
